Kamal device (available in some countries) has an FM transmitter that allows you to transmit sound from the device through the speakers of your car audio system. Pc Networking Usb 2.0 Netlink Cable Driver. To synchronize the device with the car audio system perform the following steps: Turn on the device and wait until it is in the main menu. Go to 'Settings' >'FM Transmitter' and make sure 'Use FM transmitter' option is selected. This option will have to have a check-mark for synchronization with your car audio system. It will be necessary to put the same radio frequency on the device and on the car audio system.

Ndrive Serial Serial Numbers. Convert Ndrive Serial trail version to full software.

You should choose an FM frequency between 88.0 MHz and 108.0 MHz Ideally, you should choose a frequency that is not assigned to a radio station. Note: For an optimal experience, please detach your car's antenna, if possible.

To check that the equipment is emitting sound, do the following: Open the device's main menu and select 'Settings”. Choose the option for sound and check the volume level. Then check the settings in the NDrive software (Menu >Settings >General >volume) since the sound can also be changed by the software. Note: NDrive sells its software to several OEM partners, which may use devices with specific design.

Please, always refer to the local support center if you need assistance regarding hardware. GPS Navigation To fix a GPS signal more effectively put your device on the windshield of your car, as close to the dashboard as possible so as not to affect you’re driving. When used outdoors, NDrive will have more difficulty in fixing a satellite signal in locations of dense trees or with tall buildings.

It is common not to be able to fix the satellite signal inside buildings. On first software use, the satellite fixing can take up to 30 minutes.

The waiting time decreases significantly after first use. If you're travelling by plane and you significantly change country or continent it is normal for your device to take longer to obtain a quality signal. The GPS antenna is usually located on the back, on top of the appliance and should stay pointing towards the sky as much as possible, so its placement on seats or hands could slightly decrease signal quality. There are cars on the market with bullet-proof glass that can significantly decrease (or even prevent) the reception of a satellite signal in good conditions.

In this case you should move the GPS as close as possible to the side windows that are not shielded and avoid approaching the device to the windscreen, which will block the signal. Checking GPS signal on NDrive software: start NDrive application. While on map view, the icon that indicates the status of the GPS signal should be fully shaded in red. Download Driver Sis 661 Windows 7 more. Tomtom Ov2 Creater Download here.

With the icon that color, move outdoors to a location preferably in the open. Obtaining the signal can take up to 20 minutes, after obtaining the signal the icon that indicates the status of the GPS signal will change to blue and then to green when a very good quality GPS signal is obtained.

If the GPS status icon is always grey, you should contact the NDrive technical support. If the message 'No GPS” appears, this is due to the fact that the equipment does not have an internal GPS antenna or the GPS settings of the device are not correctly set. Since each device has its specific settings, you should contact the manufacturer support so that the settings may be made available. 1 - If you are charging the device using a USB cable, please make sure the light that indicates the device is being charged is lit. If there is no indication that the device is charging, you should check the status of your USB cable and also the computer's USB ports. 2 - If the car charger is used, make sure the LED charger is lit (green or red depending on the charger). If not lit, the car charger may be damaged.